Changing settings/
Using sensors
5
SET
5/13
Changing settings/
Using sensors
22
Changing settings of the Air GPS and sensors
2
Send a sensor signal and perform pairing.
CATEYE sensor
How to send a sensor signal
Speed/cadence sensor (ISC-12)
Move the magnet through the sensor zone several
times. (The clearance must be within 3 mm.)
Magnetless speed sensor (SPD-30) or
magnetless cadence sensor (CDC-30)
Shake the sensor, or rotate the wheel or crank arm
on which the sensor is installed.
Heart rate sensor (HR-12)
Rub both electrode pads of the heart rate sensor with
your thumbs or attach them to your body.
Optical heart rate sensor (OHR-31)
Press the heart rate sensor button.
* For third party sensors, refer to their respective instruction manuals.
When Cateye Cycling™ detects a sensor signal, a message is displayed.
Tap [Pairing] to complete pairing.
* If the displayed sensor is not the one desired, tap [Skip], and then tap [Pairing]
again. Repeat that until the desired device name is displayed.
* If you want to pair another sensor, repeat the procedure again.
3
Set the tire circumference for a sensor capable of speed
measurement.
* For cadence and heart rate sensors, skip this step.
Tap [Sensor name] > [Tire Circumference] displayed under [Device], and then tap
and hold the tire circumference value to select, according to the tire size written on
the side of the tire.
* For tire circumference values, see
“Tire circumference table” (page 28)
.
Air GPS
4
Press and hold (POWER) to turn on the Air GPS.
The Air GPS connects to the smartphone (Cateye Cycling™).
Paired sensor information will be transferred to the Air GPS and the
sensors will be ready to use.
The information cannot be transferred if the Air GPS has been paired with other
third party sensors. Delete the sensors that have been paired with the Air GPS
unit. For details, see
“How to delete the sensors paired with the Air GPS unit”
Smartphone
5
After setup is completed, turn [Connect] off on Cateye Cycling.
(Long press)
