Starting
measurement
3
3/6
Starting
measurement
11
Starting measurement
Measurement flowchart
* The Air GPS cannot be connected to a smartphone during measurement.
1
Press and hold (POWER) to turn on the Air GPS.
* If the screen is blank or
(battery frame only) is displayed after
a long press of (POWER), charge the Air GPS according to the
procedure under
“Charging the Air GPS” (page 3)
2
When
(GPS signal received) is displayed, press MODE or
(POWER) to start measurement.
Standby
Measurement starts
(GPS signal unreceived)
(GPS signal received)
MODE
or
Caution!:
When pressing the MODE button with the Air GPS installed on the bracket, press
the area around the dot section on the front side of the Air GPS. Pressing other
areas strongly may result in malfunction or damage.
During measurement, measurement of the moving time starts and stops
automatically in sync with the movement of the bicycle.
* It takes time to receive the GPS signal. (Wait approximately 1 to 2 minutes in an
outdoor location with few obstacles.)
* Measurement can start even with no GPS signal or speed signal from the sensor
when the button is pressed. However, counting of the current speed and moving
time do not start until speed information is acquired.
* The measurement unit flashes during measurement.
* The icons and texts for any connected sensors will appear constant.
* If a sensor capable of measuring speed is connected (S is displayed), measuring
data is possible even while
(GPS signal unreceived) is flashing. In this case,
the location information will start to be recorded at the position where the GPS
signal is received.
(Long press)
