Catalyst 180-R, Инструкция по сборке

Страница: 45 / 74

STEP 12
Parts Required:
1 X Assembled Top Fuselage Plate (from previous step)
2 X Set Screw (M3 x 10mm long x steel)
2 X Button Head Screw (M3 x 6mm long x
blue 7075 aluminum )
2 X Standoff (Black aluminum M3 thread x 12.5mm long)
1 X Velcro Lipo Strap – Catalyst Machineworks
Assembly Process:
Run the included velcro strap through the slots in the Top Fuselage Plate (not shown pictorially below). With the Vtx
wired up, install the Top Fuselage Plate onto the main frame as shown. Install the set screws so 4mm of thread length is
exposed and use loctite on these screws. Install the M3 button head screws as shown. Press the XT60 grommet into the
oval slot in the side of the Top Fuselage Plate. This grommet works to hold your lipo pigtail in the correct location. Install
both standoffs as shown.