Catalyst 180-R, Инструкция по сборке

Страница: 23 / 74

STEP 5
Parts Required:
1 X Lipo Pigtail and XT60 Connector (Sold Separately)
1 X Grommet for XT60
Assembly Process:
Soldier your lipo battery pigtail (positive and negative wire leads) to the PDB board positive and negative pads. Be sure
to install the XT60 grommet over your wires as shown below prior to soldiering on your XT60 connector. Make sure the
pigtail is located on the right side of the board as shown in the graphic below. You should use 14 gage wires. The wires
should be cut to 60mm. Your wire ends should come straight off the PDB pads, pointing straight up. It may be
necessary to install some extra shrink tubing around the base of the wires to protect them from any sharp edges in the
main frame plate.