READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND
KEEP THEM FOR FUTURE REFERENCE.
YOUR CHILD’S SAFETY MAY BE AFFECTED IF YOU DO NOT
FOLLOW THESE INSTRUCTIONS.
WARNING:
IT MAY BE DANGEROUS TO LEAVE OUR CHILD UNATTENDED.
WARNING:
ENSURE THAT ALL THE LOCKING DEVICES ARE ENGAGED BEFORE
USE.
WARNING:
THIS PRODUCT IS NOT SUITABLE FOR RUNNING OR SKATING.
• The original equipment must not be modified.
• After it has been installed for a while, tighten up the fastening screws and check the
other components of the product.
• Always use the disabled access ramps, avoid going down kerbs and uneven ground.
• We recommend a maximum weight of 20 kg.
• Do not use accessories non approved by the manufacturer.
• This platform has been designed to carry only one child.
GENERAL INSTRUCTIONS
ASSEMBLING THE RYDER (see illustration 1)
• Screw the wheel bearing support onto each edge of the lower part of the platform.
• Place the non-slip pads on both sides of it, inserting and pressing the pivots into the
slots.
FITTING THE RYDER ON VINTAGE, VINTAGE 2 AND JAZZ (see illustrations 2-10)
• Pull the outer part of each connector to open the fastening hook
(fig.2)
.
• Position the connectors in the rear tube of the pushchair
(fig.3)
and press the hooking
part until it clicks indicating it is correctly fastened
(fig.4)
.
• Follow the instructions in reverse order to remove the Ryder
(fig.5)
.
• Adjust the platform height to the high or low position by pulling the adjustment part
outwards
(fig.6)
, lowering or raising the wheels and release it when they are at the
correct height
(fig.7)
. Use the low position for pushchairs
VINTAGE, VINTAGE 2 and
JAZZ
.
• When the Ryder is not going to be used, it can be folded up and secured with the
fastening strap
(fig.8)
.
• To install it, unfasten the rear central part of the basket then pass the upper part of the
strap through its support tube
(fig.9-10)
. Next, fasten the basket again.
CLEANING INSTRUCTIONS
• Clean the platform with a damp cloth (never use abrasive products or solvents).
• For the plastic parts and wheels, use water and a mild detergent.
7