Cassese CS1 UNI, Руководство пользователя и каталог запчастей

Страница: 11 / 40

Non contractual document - Cassese France
®
- Document non contractuel
8
MAINTENANCE
LUBRICATION
STAPLING HEAD
Periodically, remove the stapling head and clean it with an
air gun.
It is recommended to lubricate the wedge driver (use the
Cassese’s grease Z1896).
To do so, you will have to remove the stapling head with the
2,5mm Allen Key and perform this procedure.
CAUTION: WHEN USING COMPRESSED AIR, WEAR SAFETY GLASSES.
REPLACEMENT OF THE WEDGE DRIVER
Unlock the locking screw of the stapling head
with the 2.5mm Allen key that is supplied with
the machine. Pulling the head up, remove it
from the machine.
Inside the machine, using the 2.5mm Allen key,
loosen the two locking screws A and B holding
the wedge driver.
Apply some grease on the new wedge driver.
Remove excess of grease.
Then, follow the step in the order to install the
new wedge driver : 3, 2, 1.
Under the machine table, tighten back the lock-
ing screws A and B with the 2,5mm Allen key.
Check the wedge driver installation, it must be able
to slide smooth with no resistance.
Install back the needed stapling head and lock it
using the 2,5mm Allen key.
1
st
step 2
nd
step
TO SLIDE THE WEDGE DRIVER UP
3
rd
step
B
A