Cassese CS1 UNI, Руководство пользователя и каталог запчастей

Страница: 10 / 40

Non contractual document - Cassese France
®
- Document non contractuel
JOINING THE FRAME
After selecting and setting the wedge positions (page 4 & 5), check the distance between the
clamp and the moulding (page 6). Load the required type (softwood, hardwood or MDF) and
size of wedges (page 4).
1
st
step : Put the first moulding in front of the back fence 1 and push it so that its mitre end
reaches the other back fence 2.
2
nd
step : Holding it so, put the second moulding against back fence 2 and slide it until it
reaches the first moulding.
3
rd
step : Holding the mouldings in place against each other, hold the back fences 1 & 2 with
your thumbs. Move the sliding table E backwards until the wedge position stop handle 5
reaches the stapling stop 10.
4
th
step : Keeping the mouldings secure, slowly push down the pedal 7.
When the the magnetic adjustable rod clamp assembly 8 will press down on the mouldings,
speed up the movement so that the wedge is inserted more easily.
5
th
step : If there is a second wedge position (with wedge position stop handle 6 ), just repeat
the same operation by moving forward the mouldings and the sliding table
E until wedge
position stop handle 6 reaches the stapling stop 10 and repeat step 4.
NOTE* : If stapling more than one wedge in any position is desired then repeat 4
th
step.
7
REMOVING WEDGES
First, take the
tool Z24322
“wedge-magnet”.
Then, put the magnetic end into
the wedges to be removed and
pull them out after you have
pulled the handle for wedges’
loading 3 in the direction of the
arrow.
9
6
5
10
2
1
8
3
4
11
7
E