CASO DESIGN CM 1300, Оригинальное руководство по эксплуатации

Страница: 29 / 90

29
13.4.1 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:

Place the device on a firm, flat, level and heat-resistant surface with sufficient load-
bearing capacity for the device and its contents.

Choose the setup location in such a way that children cannot reach any hot surfaces on
the device.

The device is not intended to be installed in a wall or a built-in cupboard.

Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.

Do not place the device near a gas or electric cooker or an oven.

The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 20 cm all around the device.

Do not cover up any openings on the device and do not block these off.

The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.

The device and power cord should not come in contact with the hot surface. The device
could be damaged.

The installation and assembly of this device in non-stationary setup locations must be
carried out by specialist companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.
13.5 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:

Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device. If in doubt, ask your qualified electrician.

The electrical outlet must be protected by a 16A safety cut-out switch, separately from
other electricity consumers.

The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or
gangs is prohibited because of the danger of fire that is involved with this.

Make sure that the power cable is undamaged and has not been installed under the oven
or over hot or sharp surfaces.

The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a missing
or damaged protective conductor.