20
Getting Ready
As you unpack the projector, check to make sure that all of the items listed below are present.
Projector
Wireless remote controller YT-161
Test Batteries (AAA-size × 2)
AC Power Cord
Cable cover (XJ-UT Series only)
Wireless adapter YW-41 (XJ-UT312WN only)
“Where to find the User’s Guide” sheet
Warranty
This section explains the operational flow up to the point that projection is started.
1.
Load the test batteries that come with the projector into the remote controller.
Use only alkaline batteries to power the remote controller.
2.
Place the projector onto a table, desk, or stand that is level and firm, making
sure that you allow enough room around it.
“Safety Precautions” (page 7), “Operating Precautions” (page 13)
“Placing the Projector on a Desk or on the Floor” (page 25), “Setup Precautions” (page 26)
You will need to purchase special hardware to mount this projector on a wall. For details, contact
the retailer where you purchased the projector.
3.
Adjust the vertical angle of the projector.
“Adjusting the Vertical Angle of the Projector” (page 25)
4.
Use the supplied power cord to plug the projector into a power outlet.
5.
Connect the projector to an image output device and/or audio output device, and
then turn on each device.
“Connecting with Another Device” (page 27)
6.
Press the [
P
] key to turn on the projector.
The first time you turn on the projector, a “Language” window will appear in the center of the
projection screen. Select the language you want.
Unpacking
Operation Flow to Projection
