— 27 —
•
On-Chip Primary
PCI IDE
< Enabled >
•
On-Chip Secondary
PCI IDE
< Enabled >
The integrated peripheral controller contain an IDE interface with support for two IDE channels. Select
Enabled to active each channel separately.
NOTE: Choosing Disabled for these options will automatically remove the IDE Primary Master/slave
PIO and/or IDE Secondary Master/Slave PIO items on the menu.
•
USB Keyboard Support
< Enabled >
Select Enabled if your system contains a USB controller and you have a USB keyboard.
•
Init Display First
< PCI/ISA >
This item allows you to decide to active whether PCI/ISA or Onboard first.
•
POWER ON Function
< BUTTON ONLY >
This option allows users to select the type of power ON sequence for the system to follow.
•
Onboard FDC Controller
< Enabled >
Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and
you wish to use it. If you install an add-in FDC or the system has no floppy drive, select Disabled in
this field.
•
Onboard Serial Port 1
< 3F8h, IRQ4 >
•
Onboard Serial Port 2
< 2F8h, IRQ3 >
•
Onboard Serial Port 3
< 3E8h, IRQ10 >
•
Onboard Serial Port 4
< 2E8h, IRQ11 >
Select an address and corresponding interrupt for the serial ports
NOTE: Do not change this setting, since COM1 is assigned for the touch screen. It may cause system
problem.
•
UART Mode Select
< Normal >
The second serial port offers these infrared interface modes:
1. IrDA
2. ASKIR IrDA-compaliant serial infrared port
3. Normal (default value)
NOTE: The UART Mode Select will not appear on the menu once you disable the setting of Onboard
Serial Port 2.
When UART Mode Select is set ASKIR or IrDA, the options RxD, TxD Active and IR Transmittion delay
will appear.
•
Onboard Parallel Port
< 378h >
Select a logical PRN port name and matching address for the physical parallel (printer) port.
NOTE: Choosing Disabled for this option will remove the Parallel Port Mode option on the menu.
•
Parallel Port Mode
< Normal >
Select operating mode for the onboard parallel (printer) port. Select Normal unless your hardware and
software require one of the other modes offered in this field.
NOTE: Selecting EPP on this option will allow selection to the EPP Mode (EPP1.7, EPP1.9)
ECP mode selection will provide option for ECP Mode Use DMA.
Choosing ECP + EPP modes will provide selections for both EPP Mode select and ECP Mode
Use DMA.
•
ECP Mode Use DMA
< 3 >
Select a DMA channel for the port.
•
EPP Mode Select
< EPP 1.7 >
Select EPP port type 1.7 or 1.9.
Содержание QT-7300 Series
