Casio QT-7300 Series, Руководство по обслуживанию

Страница: 48 / 91

— 46 —
6-4. Touch panel test
Set the driver then activate the calibration software.
The following shows the software list and the test procedures.
Software Files
1) For DOS
* medv10.com Device Driver
* caldos.com Calibration program
2) For Windows95
* fidmour.drv Device Driver
* vfidmd.386 Device Driver
* fidmour.inf Device Driver information file
* calwinr.exe Calibration program
3) For WindowsNT
* fidtpntr.sys Device Driver
* fidtpntr.inf Device Driver information file
* calwinre.exe Calibration program
4) Inxxxxxxl.doc This file ( xxxxxx = YYMMDD)
Copy necessary files into the Floppy Disk based on you target Operation System.
Setup procedure
1) For DOS
1
Copy the Driver software into the proper directory.
2 Execute the “medv10.com”.
2) For Windows95
1
Open “Control Panel” <Click “Start”, select “Setting” then select “Control Panel”>
2
Double Click “Add New Hardware”
3 In “Add New Hardware Wizard”, Click “Next”
4
Select “No” at Hardware Automatic Detection then Click “Next”
5
Select “Mouse” at Hardware setup then Click “Next”
6 Click “Hard Disk” at Manufacture and Model selection
7 Insert Floppy Disk(Driver copied) into Drive (“A:”) then Click “OK”
8
“Fujitsu Fidmouse” will be displayed then Click “OK”
9
END (Restart the system )
3) For WindowsNT
1
Open “Control Panel”
2
Select “Mouse”
3 Insert Floppy Disk(Driver copied) into Drive(“A”)
4 Open “property” sheet in “General” then click “Use Disk”
5
Select “Fujitsu Takamisawa component Fidmouse” Then “OK”
*** START INSTALLATION ***
6 END ( Restart the system )