22
2.5 DIP Switch Setting (For DT-160IOE)
The DIP switch is located on the rear side of the Bridge Satellite Cradle. Change the ON/OFF settings according
to your required system configuration. The new settings do not go into effect until the power switch is turned off
and then back on again.
ON Upper side)
OFF(Lower side)
Not used (Always set to "OFF")
Not used (Always set to "OFF")
Host computer interface
Interface
6
RS-232C
OFF
USB *
ON
Termination setting for daisy chain connection
Termination
5
At middle
OFF
No chain/Termination*
ON
Connection mode
Mode
3
4
With Host PC*
OFF
OFF
Chain connection
ON
OFF
Communication speed between Cradles
Baud rate
1
2
115,200bps *
ON
OFF
Note:
Other DIP switch settings are used for testing and inspection purposes Because of this, you must not use any
DIP settings other than those described above.
Fig. 2.1
