Case 48083741, Руководство по обслуживанию

Страница: 57 / 61

Engine - Engine and crankcase
16. Mount the engine starter (1) . Firstly install the short
threaded portion of the three studs (2) into the flywheel
housing. Apply Loctite 747 primer to the studs and
holes. Apply two drops of
L
OCTITE
® 271™ to each
hole and stud assemble and torque immediately to 19
– 29 N·m ( 14 – 21 lb ft ). Allow Loctite adhesive to cure
20 min before installing the starter. Install the engine
starter (1) . Torque the three starter mounting nuts (3)
to 40 – 50 N·m ( 29 – 37 lb ft ).
LEIL17WHL0052AB
14
17. Connect a suitable lifting device to the exhaust system
assembly (1) (including muffler, pipe, support brack-
ets) and carefully lift it. Position and lower the exhaust
system assembly
(1) over the rear chassis of the ma-
chine.
NOTE: be sure all wire harness connections and hoses are
out of the way.
18. Install the muffler support brackets to the rear chassis
with six bolts and washers (arrows).
LEIL17WHL0053BB
15
LEIL17WHL0051AB
16
48083741_EN 31/07/2018
10.1 [10.001] / 22