Cascade CMX Pro, Руководство пользователя

Страница: 19 / 32

Page | 20
GUIDELINES FOR SAFE OPERATION GUIDELINES FOR SAFE OPERATION GUIDELINES FOR SAFE OPERATION GUIDELINES FOR SAFE OPERATION
ADJUSTING THE SEAT’S FORE/AFT POSITION ADJUSTING THE SEAT’S FORE/AFT POSITION ADJUSTING THE SEAT’S FORE/AFT POSITION ADJUSTING THE SEAT’S FORE/AFT POSITION
1) Sit on your bike with the cranks in the 3 & 9 o’clock
positions. A proper fore/aft position of the seat is achieved
when the small bump at the top of the shin on your forward
leg, directly below the knee cap (tibial tuberosity), is above
the pedal axle
2) Dismount to adjust the seat fore or aft for a better fit
3) Loosen the seat adjustment lever and slide the seat forward
or backward as desired; then tighten.
4) Note the final position mark under the seat for future
reference. (Repeat steps for seat height if necessary)
HANDLEBAR ADJUSTMENT
HANDLEBAR ADJUSTMENT HANDLEBAR ADJUSTMENT
HANDLEBAR ADJUSTMENT
Adjusting the Handlebar height
1) Handlebar height is matter of preference. Start with the
handlebars at the same height as the seat.
2) Adjusting the handlebars higher will give the rider a more
upright position; lowering them will result in a more prone
position.
3) Dismount the bike and pull out the pop pin on the handlebar
post.
4) Raise or lower the handlebar by pulling up on the handlebar
and sliding the handlebar post up or down as desired. When
the handlebar is in the desired position, insert the pin into
the desired hole to secure the seat post and tighten the T
handle
5) Note the final position mark on the handlebar post for future
reference.