Cascade CMX Pro, Руководство пользователя

Страница: 14 / 32

Page | 15
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
STABILIZERS STABILIZERS STABILIZERS STABILIZERS/ / / / HANDLEBAR HANDLEBAR HANDLEBAR HANDLEBAR POST AND POST AND POST AND POST AND
HANDLEBAR
HANDLEBAR HANDLEBAR
HANDLEBAR ASSEMBLY
ASSEMBLY ASSEMBLY
ASSEMBLY
1) Align the front stabilizer (the one with the
transport wheels) with the holes in the
main frame, below the flywheel.
2) Attach the stabilizer with (2) M8x60mm
screws and (4) Washers(two on top of
frame and two on bottom of stabilizer).
3) Tighten with the provided Hex key and multi tool.
4) Attach the handlebar to the handlebar post using the included
adjustment handle and square washer. The simplest way to
do this is put the handlebar on the ground
upside down and then place the handlebar
post over the handlebar and attach using the
adjustment handle and square washer(make
sure the square washer is on the adjustment
handle with the smaller side facing the
handlebars) and tighten.
5) Loosen and then pull the T handle on the frame while inserting the
handlebar post and handlebar into the front frame opening.
Tighten the T handle.
6) Standing in front of the bike, grab the handlebars and tip the bike
forward and rest the handlebars on the ground. Be careful not to
let the frame fall over to either side.
7) Align the rear stabilizer (the one with the stretch pads) with
holes in the main frame as shown
8) Attach the stabilizer with (2) M8x60mm screws and (4)
Washers(two on top of frame and two on bottom of stabilizer)