Cascade Sciences CVO-5-EX Series, Руководство по установке и эксплуатации

Страница: 45 / 132

45 | P a g e
cascadesciences.com
|
Tel. 503 847-9047
INSTALLATION
Note:
The installation party must possess the required competencies for installing equipment in
the hazardous location zone.
I
NSTALLATION
P
ROCEDURES
C
HECKLIST
For installing the oven in a new workspace location.
Pre-Installation

Verify a vacuum supply source suitable for your application is available and can be
connected to the oven, page 33.
• See page 59 for the oven gas and vacuum port locations.

Arrange for a workspace ventilation assessment if one has not been performed, page 46.

Check that the required ambient conditions for the unit are met, page 48.

Check that the spacing clearance requirements are met, page 49.
• Unit dimensions may be found on page 12.

Check that a suitable electrical power supply is present.
•
For ovens with power cords, see page 50.
•
For ovens with hardwire power feeds, see page 53.
Install the oven in a suitable workspace location.
 Review the lifting and handling instructions, page 56.
 Level the oven, page 57.
 Install the oven in its workspace location, page 57.
Set up the oven for use.

Clean the oven shelving. Clean the chamber if needed, page 58.

Install the shelving, page 58.

Connect the vacuum supply to the oven, page 59.

Connect the oven to its pressurized gas supply source, page 62.
•
A separate, optional backfill gas supply may also be connected, page 63.
 Hardwire Ovens
: Wire the oven to its power source but do not energize the supply circuit
at this time except to test, page 64.