cord location during operation. Follow-
ing this rule will reduce the risk of electric
shock or fire.
6. Always check for damaged parts. Before
further use of the tool, a guard or other
parts that are damaged should be carefully
checked to determine if it would operate
properly and perform its intended function.
Check for misalignment or binding of mov-
ing parts, breakage of parts and any other
condition that may affect the tool’s opera-
tion. A guard or other part that is damaged
should be properly repaired or replaced
at an Authorized Service Center. Follow-
ing this rule will reduce the risk of electric
shock, fire or serious injury.
7. Do not abuse the cord. Never use the cord
to carry the tool or pull the plug from the
outlet. Keep cord away from heat, oil, sharp
edges or moving parts. Replace dam-
aged cords immediately. Damaged cords
increase the risk of electric shock. Follow-
ing this rule will reduce the risk of electric
shock or fire.
8. Dual Blade Saw can saw wood with nails,
but it is advisable to remove all nails from
wood before sawing. Following this rule will
reduce the risk of serious personal injury.
9. Do not operate the tool while you are tired
or under the influence of drugs, alcohol,
or any medication. Following this rule will
reduce the risk of electric shock, fire, or
serious personal injury.
SAVE THESE INSTRUCTION
Refer to them frequently and use them to
instruct others who may use this tool. If some-
one borrows this tool, please make sure that
they have these instructions also.
• Lead from lead-based paints.
• Crystalline silica from bricks and cement
and other masonry products.
• Arsenic and Chromium from chemically
treated lumber.
• Your risk from these exposures varies
depending upon how often you do this
work. To reduce your exposure to these
chemicals.
• Work in a well-ventilated area.
• Work with approved safety equipment, such
as those dust masks that are specially des-
ignated to filter out microscopic particles.
The operation of any circular saw can result in
foreign objects being thrown into your eyes,
which can result in severe eye damage. Before
beginning power tool operation, always wear
safety gloves and safety glasses with side
shield and a full-face shied when needed.
4. KNOW YOUR DUAL BLADE
SAW
Your Dual Blade Saw has many built-in
convenience features for fast, efficient cutting.
These features include an innovative Two
Saw Blade System where the blades spin in
opposite directions to provide smooth, clean
cuts with less vibration and kickback. It also in-
cludes a pre installed blade lubricating system
for cutting aluminum, copper, stainless steel
and cast iron.
For your convenience, there is no special
assembly required for your Dual Blade Saw
handle, except assist for specification refer to
DATASHEET.
5. OPERATING INSTRUCTIONS
SAW BLADES
Even the best saw blades would not cut ef-
ficiently if they are not kept clean, sharp and
properly set. Using a dull blade will place a
heavy load on your saw and increases the
danger of kickback. Keep extra blades on
hand, so sharp blades are always available.
Gum and wood pitch hardened on your blade
will slow your saw down. Use gum and pitch
remover, hot water, or kerosene to remove
these accumulations. Do not use petrol.
This Dual Blade Saw uses specially designed
blades and no other types of blades should
ever be used. Other blades will not operate
safely in this saw and could result in serious
personal injury.
Содержание DBS900
Страница 10: ......
