8
Message: All screens described below can display an information
message in the band at the bottom.
Message
Status
COMMUNICATION FAILURE!
Equipment controller did not respond while
reading the table content.
ACCESS DENIED!
Equipment controller does not allow accessing
one of the table data blocks.
LIMIT EXCEEDED!
The value entered exceeds the table limits.
Save changes?
Modifi cations have been made. The web
interface waits to confi rm exit by pressing Save
or Cancel.
HIGHER FORCE IN EFFECT!
Force or Auto command was rejected by the
equipment controller because the interface
force level is lower than the equipment
controller’s level.
4.4 - On/off screen
4.4.1 - Unit start-up
With the unit in Local Off mode, press
to display the list
of operating modes. Select the required mode.
Shows the last
mode selected
Operating
mode list
Confi rm the unit shut-down or return to the previous
screen.
Stopping the unit: press button
4.5 - Password/language screen
1
Cursor showing the activated language
2
Logged in
3
Unit of measurement selection: Metric/Imperial
4
Enter the password
5
Logged off
ATTENTION: Validation of password only effective
after the log-in button has been pressed.
4.6 - Menu screen
To access the menu press button
Touch the required item to access the table/menu.
4.7 - Confi guration screen
1
Save
2
Cancel
3
Message
4
Previous page
5
Next page
①
②
③
④
⑤
① ②
③
④ ⑤
