Carrier RHW036-060, Руководство по установке

Страница: 10 / 44

10
Specifications subject to change without notice.
10
Fig. 5 — Rigging Details
Step 7 — Convert to Horizontal and Connect
Ductwork (when required)
Unit is shipped in the vertical duct configuration. Unit without
factory-installed economizer or return-air smoke detector
option may be field-converted to horizontal ducted configu -
ration. To convert to horizontal configuration, remove
screws from side duct opening covers (see Fig. 6) and re -
move covers. Use the screws to install the covers on verti -
cal duct openings with the insulation-side down. The panels
must be inserted into the notches on the basepan to proper -
ly seal. The notches are covered by the tape used to secure
the insulation to the basepan and are not easily seen. See
Fig. 7 for position of the notches in the basepan. Seals
around duct openings must be tight. Secure with screws as
shown in Fig. 8. Cover seams with foil duct tape.
Field-supplied flanges should be attached to horizontal duct
openings and all ductwork should be secured to the flanges.
Insulate and weatherproof all external ductwork, joints, and
roof or building openings with counter flashing and mastic in
accordance with applicable codes.
Do not cover or obscure visibility to the unit’s informative
data plate when insulating horizontal ductwork.
Fig. 6 — Horizontal Conversion Panels
Fig. 7 — Location of Notches
Fig. 8 — Horizontal Duct Panels In Place
DETAIL "A"
PLACE ALL SEAL STRIP IN PLACE
BEFORE PLACING UNIT ON ROOF CURB.
DUCT END
SEE DETAIL "A"
"A"
(914-1371)
36"- 54"
"C"
"B"
SPREADER
BARS
REQUIRED
NOTES:
1. SPREADER BARS ARE REQUIRED. Top damage will occur if spreader bars are not used.
2. Dimensions in () are in millimeters.
3. Hook rigging shackles through holes in base rail, as shown in Detail A. Holes in base rails are centered around the unit center
of gravity. Use wooden top to prevent rigging straps from damaging unit.
UNIT
MAX WEIGHT
DIMENSIONS
A B C
lb kg in. mm in. mm in. mm
RHW036
772 350 74.5 1890 36.0 915 33.5 850
RHW048 964 437 74.5 1890 35.4 900 41.5 1055
RHW060
986 447 74.5 1890 35.4 900 41.5 1055
REMOVABLE HORIZONTAL
SUPPLY DUCT OPENING COVER
REMOVABLE HORIZONTAL
RETURN DUCT OPENING COVER
BASEPAN
NOTCHES
NOTCHES
SCREWS
DUCT COVERS
SHEET METAL
FACE UP
BASEPAN