Carrier P1 Series, Инструкция для владельца и по установке, Страница: 9 / 38

When two units are used in the same room, you can match the address of
the remote control to that of the unit.
Turn off the unit and pull out the power plug. Remove the insert grille and
terminal block cover.
Assign the address switch of one indoor unit as B.
Remove the lid of the battery case. Assign the address switch of one
remote control as B.
Press the RST button with a sharp object.
• A mounting bracket for the remote control is
supplied with the unit. Install the mounting bracket
on the wall 30cm below the receiver of the unit.
Use the remote control where its signals can reach the receiver of the air conditioner.
(A distance of 5m is allowed)
• You can hear a beep from the unit which indicates that the signal is received.
5m maximum
• The air conditioner will not operate if curtained,
doors or other materials block the signals from
the remote control to the unit.
• If the infrared signal receiver on the unit is exposed
to direct sunlight, the air conditioner may not work
properly. Draw the curtains to avoid direct sunlight.
CAUTION
7
BEFORE OPERATION
Matching Address between Indoor Unit and Remote Control
Signal Receiving
Indoor Unit
Remote control
• This function must only be performed by qualified service personnel.
NOTE