Carrier P1 Series, Инструкция для владельца и по установке, Страница: 27 / 38

• Tie the refrigerant pipe, the drain hose, and the electrical connection
cord together.
• Form the refrigerant piping in the required direction, and bind the drain hose
and the electrical connection cord together with vinyl tape.
The drain hose should be at the bottom. ( Figure. 9 )
• For Left Piping, fit the pipes and the wiring into the recess at the back of
the unit as shown in Figure 10.
Drain hose
Left piping
Bind with vinyl tape
Indoor unit piping
Figure 9
• Pass the pipes through the wall sleeve and then hook the indoor unit body onto the top of the wall hang bracket. ( Figure. 11 )
• For Left Piping, hang the unit onto the top of the wall hang bracket and incline the unit using a tool such as a screw
-driver set between the middle area of body and bottom right of the wall hang bracket.
Connecting the pipe can be done more easily if the unit is inclined.
• Snap the marking places of the body(A, B) onto the hole of the bracket.
Indoor unit piping
Connection cord
Drain hose
Figure 10
25
123456789012345678901234567890121234567890123456789012345678901212345678
123456789012345678901234567890121234567890123456789012345678901212345678
123456789012345678901234567890121234567890123456789012345678901212345678
123456789012345678901234567890121234567890123456789012345678901212345678
123456789012345678901234567890121234567890123456789012345678901212345678
4) Forming the Drain Hose and Refrigerant Piping
123456789012345678901234567890121234567890123456789012345678901212345678
123456789012345678901234567890121234567890123456789012345678901212345678
123456789012345678901234567890121234567890123456789012345678901212345678
123456789012345678901234567890121234567890123456789012345678901212345678
123456789012345678901234567890121234567890123456789012345678901212345678
5) Installing the Indoor Unit Body to the Wall Hang Bracket
INDOOR UNIT INSTALLATION