Installation
4
i-Vu Open Link
To install the i-Vu Open Link:
1
Mount the i-Vu Open Link.
(page 4)
2
Wire for power.
(page 5)
3
Wire for communications
(page 5).
4
Connect the i-Vu Open Link to the Ethernet
(page 6).
5
Set the i-Vu Open Link's address and IP address.
(page 7)
To mount the i-Vu Open Link
When you handle the i-Vu Open Link:
•
Do not contaminate the printed circuit board with fingerprints, moisture, or any foreign material.
•
Do not touch components or leads.
•
Handle the board by its edges.
•
Isolate from high voltage or electrostatic discharge.
•
Ensure that you are properly grounded.
Screw the i-Vu Open Link into an enclosed panel using the mounting slots on the cover plate. Leave about 2
in. (5 cm) on each side of the controller for wiring.
Mounting hole dimensions:
•
11.25" (27.64cm) width
•
1.25" (31.75mm) top edge to center of first hole
•
3.75" (63.5mm) top edge to center of second hole
Installation
