Carrier 69NT40-541-306, Операция и обслуживание

Страница: 51 / 154

4–15 T-354
4.6.9 Pre-Trip Data Recording
The DataCORDER will record the initiation of a pre-trip test (refer to Section 4.5 ) and the results of each of the
tests included in pre-trip. The data is time-stamped and may be extracted via the Data Retrieval program. Refer to
Table 4–9 for a description of the data stored in the DataCORDER for each corresponding pre-trip test.
4.6.10 DataCORDER Communications
Data retrieval from the DataCORDER can be accomplished by using one of the following; DataReader, DataLine/
DataView or a communications interface module.
NOTE
A DataReader, DataLine/DataView, or a communications interface module display of Communication
Failed is caused by faulty data transfer between the DataCORDER and the data retrieval device.
Common causes include:
1. Bad cable or connection between DataCORDER and data retrieval device.
2. PC communication port(s) unavailable or mis-assigned.
3. Chart Recorder Fuse (FCR) blown.
Communication identification for the models covered herein may be obtained on the Container Products
Group Information Center by authorized Carrier Transicold Service Centers.
A. DataReader
The Carrier Transicold Data Reader (see Figure 4.6 ) is
a simple to operate hand held device designed to
extract data from the DataCORDER and then upload it
to a personal computer. The Data Reader has the abil-
ity to store multiple data files. Refer to Data Retrieval
manual 62-10629 for a more detailed explanation of
the DataReader.
B. DataBANK
TM
Card
The DataBANK
TM
card is a PCMCIA card that interfaces
with the controller through the programming slot and can
download data at a much faster rate when compared to
the PC or DataReader. Files downloaded to the Data-
BANK card files are accessible through an Omni PC
Card Drive. The files can then be viewed using the
DataLINE software.
C. DataLINE
The DataLINE software for a personal computer is sup-
plied on both floppy disks and CD. This software allows
interrogation, configuration variable assignment,
screen view of the data, hard copy report generation,
cold treatment probe calibration, and file management.
Refer to Data Retrieval manual 62-10629 for a more
detailed explanation of the DataLINE interrogation soft-
ware. The DataLINE manual may be found on the
Internet at www.container.carrier.com.
Figure 4.6 Data Reader
D. Communications Interface Module
The communications interface module is a slave module which allows communication with a master central moni-
toring station. The module will respond to communication and return information over the main power line. With a
remote monitoring unit installed, all functions and selectable features that are accessible at the unit may be per-
formed at the master station. Retrieval of all DataCORDER reports may also be performed. Refer to the master
system technical manual for further information.
DataReader