Inverter Hybrid Boiler
22
Installation of wired remote controller
How to install a wired remote controller
1
2
Install a wired remote controller on the wall of room to be heated.
The installation location should be a well-ventilated spot that is 1.2 to 1.5 meters above the floor.
<Example of location for the installation of wired remote controller>
①
Remove the bracket of the remote controller using a screwdriver, as shown in on the left of below
figure.
②
Place the bracket on the installation location and firmly fix it with the 4 screws provided.
③
Connect the communication cable to the power and communication terminals in the back of the wired
remote controller.
④
Connect the opposite end of the communication cable to the terminal of hydro unit.
Do not install the remote controller in a location that is close to a frequently opened door, a location
that is exposed to a cold wind or direct sunlight, or a location that is within the reach of a child.
(O) Well-ventilated place
A place that is not directly
exposed to hot wind from
a heating device
(X) Poorly ventilated place
(X) A place near a window
or door subject to the
influence of drafts from
the gap
(X) A place subject to
the direct influence of
radiator or other heat
Selection of installation location
A1
B1
+
–
Outdoor unit
communication
(shield cable)
▶
Terminal block connection
Clamp button
12V GND B
A
A
B
1. UPT cable processing
2. Connection on the hydro unit
3. Connection on the wired
remote controller
(
)
CN14
Tact
스위치
!
Orange
White/
Orange
White/
Green
White/
Brown White/
Blue
Green Brown
Brown cable bundle
Green
White
Blue
Blue cable bundle
As shown in the figure above, cut the orange
cable bundle, remove the wire clothing at the
end and twist the wires of blue cable bundle
and brown cable bundle. Untwist the wires in
the green cable bundle and separate white
cable from green cable. The clothing of these
wires should be removed as well.
A1 : Green / B1 : White
+ : Brown bundle / - : Blue bundle
Connect the wires to the corresponding
terninals as shown in the figure above and
then securely tighten all fixing screws.
A1: Green / B1: White
+ : Brown bundle /
- : Blue bundle
Wired Remote Controller
+
-
B1 A1
+
-
B1 A1
