23
settings for tHe control unit
The use of these settings is for version 3.17 of the firmware.
The settings could change in the future. If your firmware is a differnet version than 3.17,
please contact
cArPetligHt
GmbH.
switching on/off
Once the lamp is successfully connected to the control unit and that is connected to a
functioning power supply, the lamp is ready for use. Once the main switch on the control
unit has been activated, the
cArPetligHt
-Logo will appear in the display. The lamp always
starts in the On-mode and the illumination will be the same as the last set up which was
input into the control unit. This includes it´s brightness and color temperature.
Brightness and color temperature
Once the control unit and lamp body have been successfully connected, the use of
brightness and color temperature settings can be seen in the display.
For setting the brightness please use the brightness control.
For setting the color temperature please use the color temperature control.
The color temperature can be seen in the display and is measured in Kelvin (K), and can
be controlled in 50 K increments. The wanted value is displayed in 100 K increments.
The small square which shows when the control knob is continuously adjusted shows
the 50 K increments.
selection using the Menu function / standby-Mode
Pressing down the stand-by button briefly, will put the lamp into stand-by mode and
switch the lamp off. Pressing down on the button again will turn the light back on to its
previous setup before the lamp was turned off. To switch the lamp off turn the main
switch off.
By pressing down the standby/menu button for 3 seconds you are now in the options
menu. By pressing down the standby/menu Button for another 3 seconds you are then
in the lamp operation mode. Once in the options menu, using a short press of the button
you can go through the menu functions. Use the color temperature control to change
menu functions and its corresponding value.
