Carl Valentin Spectra II, Руководство по обслуживанию

Страница: 40 / 76

Adjustments, settings and alignments Spectra II
40 Service Instructions 09.16
If the cut is incorrect, the pressure between cutter shaft (H) and cutter
ledge (G) is to be increased as described below:
1. Remove the right side cover of the cutter unit.
Remove the 3 screws of the hexagon head bolts (B).
2. Loosen the 2 screws (A) of the spacer pillar (F).
3. Turn the spacer pillar (F) slightly downwards with a flat spanner
(size 8).
4. Tighten again the 2 screws (A).
5. Start a single cut.
In the main menu of printer of if a print order has been stopped,
press key to start a single cut.
In case the quality of the cut is not sufficient then repeat the above
mentioned steps.
If the pressure is too strong this could result in an increased ware.
Therefore select the pressure only as high as it is necessary for the
used material.
Switch off the printer and mount again the cutter unit in reverse order.