15
6.
Seat the blind nut by using one of the 4mm
bolts and a flat washer without the mounts.
Pull the blind nut firmly into the firewall using
the screw. Repeat for the other 3 screws.
7.
Bolt the engine in place being sure to use lock-
tite on all the screws.
8.
Drill a 9/64” hole in line with the throttle output
arm on your engine and insert the nylon tube for the
throttle pushrod.
Throttle Servo
1.
Collect the following items:
(1) e-z servo connector
(1) Laser cut plywood mount
(1) 2-56 threaded one end pushrod
(1) 2-56 clevis
(1) clevis retainer
5.
With the motor on the mounts, center the
mounts on the two line you drew on the fire-
wall.
Mark the location of the holes and drill a .160
diameter hole at each location.
Open the hole up with a .200 diameter drill (the
shoulder of the blind nut is .200)
