11
Insert the linkage with a little Loctite
from the servo side and screw it into the
mounted clevis.
Clip the clevis into the servo horn. It
might be helpful to set the servo in a
right-angled position again, remove the
servo horn, connect it to the clevis and
then permanently install the servo horn
right-angled.
Tighten the center screw with Loctite.
Install the wiring for the Slat servo
through the wing root.
For the inner slat servo, adjust the
linkage for the inner servo like to approx.
108mm.
Then grind the linkage hole the bottom
of the rip. Don’t damage the CFK string.
108mm
Slat servo installation
