1000DF00329 Issue 4
2/36
Introduction
The Alaris® CC Syringe Pump (herein after referred to as "pump") is a fully featured high end variable pressure syringe pump suitable for
critical care applications.
The Alaris® CC Syringe Pump functions with a wide range of standard, single-use, disposable Luer lock syringes. It accepts syringe sizes from
5ml to 50ml. See the 'Compatible Syringes' section for a full list of compatible syringes.
Intended Purpose
The Alaris® CC Syringe Pump is intended for use by medical staff for purposes of controlling infusion rate and volume.
Conditions of Use
The Alaris® CC Syringe Pump should only be operated by a clinician competent in use of automated syringe pumps and post-placement
management of intravenous catheters.
A
CareFusion cannot guarantee the continued system accuracy with other manufacturer’s syringes as identified in the
‘Compatible Syringes’ table. Manufacturers may change syringe specification significant to system accuracy without
prior notification.
Indications
The Alaris® CC Syringe Pump is indicated for infusion of therapeutics including:
• analgesics
• antimicrobials
• blood products
• chemotherapy
• nutrition
• subcutaneous
• epidural
Contraindications
The Alaris® CC Syringe Pumps is contraindicated for:
• enteral therapies
Quick Start Guide
1.
Press the
a
button to turn the pump on.
2.
CLEAR SETUP?
-
NO
retains previous data.
YES
clears previous data.
3.
Load syringe.
4.
Confirm correct size and brand of syringe.
5.
Ensure extension set is attached to syringe, but disconnected from patient. Insert pressure disc into pressure transducer.
If the PURGE SYRINGE option has been enabled then the prompt to purge screen is displayed and the set can be purged as
required.
6.
INFUSION RATE - Change rate if necessary using the
f
keys.
7.
PURGE - Press the
i
button followed by the
PURGE
softkey.
8.
Connect extension set to the patient access device.
9.
Press the
b
button to start the infusion.
About This Manual
The user must be thoroughly familiar with the Alaris® CC Syringe Pump described in this manual prior to use.
All illustrations used in this manual show typical settings and values which may be used in setting up the functions of the pump. These
settings and values are for illustrative use only. Where stated, a minimum infusion rate refers to a nominal rate of 1.0ml/h, and an
intermediate infusion rate refers to a nominal rate of 5.0ml/h. The complete range of infusion rates, settings and values are shown in the
Specifications section.
A
It is important to ensure that you only refer to the most recent version of the Directions for Use and Technical Service
Manual for your CareFusion products. These documents are referenced on www.carefusion.com. Copies can be
obtained by contacting your local CareFusion representative.
