Carefree of Colorado Service
Manual
F
REESTYLE
RM
070014-301r6
7
10. Roll the fabric onto the roller tube leaving enough material to reach between the case and the lead rail.
11. Align the one-way drive and bearing in the roller tube and slide the motor into the roller tube.
12. Secure the fabric on the roller tube with the retaining screws through the bearing and end plug. Note: The
screw must be positioned to thread into the metal of the roller tube slot and the edge of the canopy
polycord.
13. Slide the fabric into the lead rail and the roller tube into the case.
14. Seat the motor in the LH end plate. Ensure that the motor is oriented with the limit switches pointed toward
the access holes in the end plate.
15. On the idler side, position the roller tube end plug into the end plate and attach the end plate to the
case. It is not necessary to close the cover at this time.
16. On the motor side, secure the motor to the end plate with the motor screws removed previously.
17. Attach the motor and harness wires (Blue to Brown and Brown to Blue). Fold and tuck the wires and
connectors to fit inside the end cap when installed.
18. Restore power to the awning.
19. Open and close the awning to confirm that the fabric rolls and unrolls squarely. Adjust the fabric
position in the lead rail as required.
20. Attach the RH lead rail end plate.
NOTE:
The top screw of the lead rail end plates secures the fabric in the lead rail. The screw should
be positioned to thread into the metal of the lead rail and the edge of the polycord.
21. Attach the fabric retaining screw into the LH lead rail end plate.
22. Close and secure the cover. There are two screws on each end of the awning.
23. After installing the canopy, it may be necessary to adjust the motor limits. Refer to "Adjusting the Motor
Limits" on page 3.
