8200-M535-O1 Rev B
225-DS
4
INSTALLATION, CONT.
Figure No. 2
6. Next, referring to Figures No. 2 and 3,
locate the 6-32 threaded stud in the
lower right corner of the enclosure
securing the main board.
NOTE!
This is
where the ground wire from the 225-DS
will be connected.
7. To attach the ground wire, remove the
6-32 nut and washer and then place the
ring terminal from the 225-DS ground
wire over the 6-32 threaded stud.
Reinstall the washer and 6-32 nut and
tighten. Refer to Figure No. 3.
NOTE!
Position the ring terminal with
the wire extending away from the main
board as shown to prevent shorting.
8. To install the Dual Scale Input Card,
carefully align the dual row of pins on
the top of the 225-DS card (on the trace
side of the card) with connector P2 on
the main board and apply even
downward pressure to the edge of the
225-DS. See Figure No. 4.
Threaded
Mounting
Spacers
Connector
P2
6-32
Threaded
Stud
Figure No. 3
6-32
Threaded
Stud
225-DS
Ground
Wire
Figure No. 4
Align pins
with holes
in P2
Содержание 225-DS
Страница 2: ...8200 M535 O1 Rev B 225 DS 2...
Страница 19: ...8200 M535 O1 Rev B 225 DS 16...
Страница 20: ...8200 M535 O1 Rev B 225 DS 17...