docs.carbide3d.com
8/26/2020
Version 1.0
10
a.
Use an 8mm wrench and a 4mm hex key to remove the two (2) M5 nuts and two (2) M5
×
16mm SHCS.
8.
Remove the lower two V-wheels from the X/Z-carriage.
a.
Hold the eccentric nuts steady with an 8mm wrench and use a 3mm hex key to remove the V-wheels.
9.
Lift the X/Z-carriage away from the X-rail and lay it on the baseframe.
Disassemble the X/Z-Carriage
1.
Separate the Z-carriage from the X-carriage.
Fig. 6
.
a.
Remove the springs from both sides of the
X/Z-carriage.
b.
Loosen the tensioning screw at the
bottom of the X-carriage plate.
i.
Use a 3mm hex key to loosen the
tensioning screw.
c.
Loosen the idler assembly at the bottom
of the X-carriage and free the belt.
ii.
Use a 4mm hex key and a 10mm
wrench to loosen the nut holding
the idler in place.
iii.
Free the belt from the idler and
the Z-motor pulley.
d.
Slide the smaller Z-carriage down and
away from the larger X-carriage.
2.
Remove the router/spindle mount from the
Z-carriage plate.
b.
Use a 3mm hex key to remove the two
M5
×
16mm BHCS securing the mount.
c.
CARRY OVER
the router/spindle mount
and M5
×
16mm BHCS.
3.
Remove the X-motor (lower motor) from the back
of the X-carriage plate.
d.
Use a 4mm hex key to remove the four
M5
×
10mm SHCS securing the motor.
e.
CARRY OVER
the X-motor.
Figure 6
WARNING:
Do not mix up the X- and Z-motors. The orientation of the X-motor
’s
drive pulley on the drive shaft
is very important for Z-Plus assembly. See
Fig. 7.
Figure 7
