12
Connection and operation
Warning
Read warning notice and
instruction manual carefully
prior to initial operation and
save the information for later
use.
Permissible installation
Mains connection
Connect the machine to the correct mains supply. Please
read the type plate (U
1
) on the rear side of the machine.
0
l
1
2
Important!
In order to avoid destruction of
plugs and cables, good electric
contact is required when connecting
earth cables and welding hoses to
the machine.
Connection of shielding gas
Connect the gas hose, which branches off from the
back panel of the welding machine (3), to a gas supply
with pressure regulator (2-6 bar). (Note: Some types of
pressure regulators require an output pressure of more
than 2 bar to function optimally).
One/two gas cylinders can be mounted on the bottle
carrier on the back of the trolley.
Connection of welding hose
Moreover, a MIG Manager kit (optional) needs to
be mounted with a multiplug on the front of the
machine (7) if the welding hose is equipped with a MIG
Manager®.
Connection of electrode holder for MMA
The electrode holder and earth cable are connected to
plus connection (8) and minus connection (6). Observe
the instructions from the electrode supplier when
selecting polarity.
1. Mains connection
2. Power switch
3. Connection of shielding gas
4. Connection of welding hose
5. Welding hose
6. Connection of earth clamp (MIG) or electrode
holder
7
Connection of MIG Manager® or push-pull welding
hose (option)
8. Connection of earth clamp (MMA) or electrode
holder
9. Power switch for autotransformer (optional)
10. Activation of autotransformer in standby (optional)
Lift instructions
The lifting points must be used
(please see figure) when lifting the
machine.
The machine must not be lifted with
mounted gas bottle.
Do not lift the machine by the
handle.
Do not step on the handle.
Power
F
F
F
GAS
2-6 Bar
1
2
3
4
5
6
8
9
10
7
