27
GB
OPERATION
START/STANDBY/SLEEP MODE/OFF
1.
Start
Switch ON the power switch on the bottom of robot vacuum cleaner (the robot vacuum cleaner will beep twice and is then in standby
mode – the LED shows blue).
Press the CLEAN button on the vacuum cleaner (or the ON/OFF button on the remote control) to start cleaning. The robot vacuum
cleaner will beep three times and the LED will show blue during cleaning.
Note! If the robot vacuum cleaner is in sleep mode, press CLEAN for one second to start it. Then press CLEAN again to start automatic
cleaning.
b. If the robot vacuum cleaner is in standby mode for more than 15 minutes, you must press the CLEAN button to return to normal
mode.
2.
Standby
Press the button to stop cleaning temporarily.
A. Press the CLEAN button on the vacuum cleaner
B. Or press the ON/OFF button on the remote control.
Note! When the robot vacuum cleaner is in standby, a new mode can be selected.
3.
Sleep mode
The robot vacuum cleaner enters sleep mode and the LED on the display goes out (the robot vacuum cleaner is in standby mode, not
OFF).
A. The robot vacuum cleaner will enter sleep mode automatically if it does not receive a command within 30–60 seconds.
B. Press and hold CLEAN for one second to switch the robot vacuum cleaner to sleep mode.
Note: Switch OFF the power switch if the robot vacuum cleaner is not to be used for longer periods.
4.
OFF
Switch OFF the robot vacuum cleaner.
SCHEDULED CLEANING
You can use the remote control to program the robot vacuum cleaner to clean at a given time.
•
Follow the instructions below to set the time when the robot vacuum cleaner is to be in standby mode or charged at the charging
station (docking). Press the CLEAN button on the vacuum cleaner (or the ON/OFF button on the remote control) to start the robot
vacuum cleaner. If the robot vacuum cleaner is in cleaning mode, stop it before starting the programming procedure (setting the
timer).
•
Point the remote control at the signal receiver on the robot vacuum cleaner, press the PLAN button until the LED shows pink (this
indicates programming is complete).
•
Press the PLAN button to check whether the robot vacuum cleaner is already programmed for scheduled cleaning. If it is, the LED
shows pink for two seconds. If it is not, the LED does not change colour and you will hear a beep.
•
To cancel the time setting: Switch OFF the robot vacuum cleaner at the power switch. When it is switched ON again, the time
setting will be cancelled.
Note!
A. When the time setting has been confirmed, the robot vacuum cleaner will always clean as per the specified time.
B. All time settings are cancelled if the robot is switched OFF. If the robot vacuum cleaner is not used for one minute it will enter sleep
mode.
C. During charging with an adapter connected directly to the robot vacuum cleaner (charging without docking), time settings cannot
be programmed.
