SmartLock
®
Pro
Page 3 of 29
Installation Manual
April 2009 • Rev. 1.7
Introduction
The SmartLock
®
Pro access control panel is a single door controller with
inputs for both entry and exit readers. Readers and card formats supported
include standard 26-bit and 37-bit (Cansec) Wiegand formats, and Cansec
iButton
®
credentials. Other card formats can be accommodated with the use
of
Cansec Protocol Converters
(contact Cansec for further information).
SmartLock controllers can be used with SmartLock Pro, SmartLock Connect
and SmartLock Online software (SmartLock Online requires legacy firmware;
controller ordered as CA-SOLCTRL).
The SmartLock control panel stores all cardholder data in non-volatile
memory to ensure continued operation and security in the event that
communications are lost to the host PC. Up to two control panels are easily
mounted in a SmartLock enclosure along with a Cansec 12 VDC power
supply and a back-up battery.
DIODES
Diodes are
required
for inductive loads such as electric strikes/locks. Failure
to use appropriate diodes will void the control panel warranty.
POWER SUPPLY NOTICE
In some jurisdictions, the use of a UL approved power supply and
connection to the fire alarm system for emergency release may be required.
Installers should contact the local authority having jurisdiction to verify the
specific requirements. Also, a building permit may be required in some
jurisdictions for the installation of maglocks.
