Warning! Before each use, check the condition of all elements for cracks, tears, discoloration or
deterioration, as they may affect the effectiveness of the device.
How to disinfect the teat?
Before first and subsequent use wash the teat with warm water then place it in boiling water for 5 min.
This is to ensure hygiene. Clean before each use. Do not use any antibacterial agents! Inspect carefully
before each use especially when baby has teeth. Pull the teat in all directions. Throw away at the first signs
of damage or weakness. Do not tighten up bottle locking ring, as it may disturb its ventilation. Always
check for leakage. Never enlarge the teat flow holes by any means, as it may damage the teat. Do not
leave the teat in a direct sunlight, close to a source of heat, or in disinfectants (sterilizing solution) longer
than recommended, as this may weaken the teat. It is recommended to replace a teat max. after 2 months
of use to ensure safety and hygiene.
After use, clean the bottle and the teat from food remains, rinse and then wash thoroughly with hot water;
do not boil. The bottle is dishwasher safe (max. temp.65°C). Do not wash the teat in the dishwasher
because detergents / cleaning agents can cause damage to the product.
For your child safety and health WARNING!
Always use this product under adult supervision. Never
use feeding teats as soothers. Continuous and prolonged suckling of fluids may cause tooth decay. Always
check food temperature before feeding. Warming in microwave oven may result in locally high temperature.
If warming feed in microwave, oven remember to leave the bottle open. Take particular care when heating
in a microwave. Always stir heated feed to ensure even distribution of temperature and check liquid
temperature before giving it to the child.
Warming breast milk in microwave is not recommended. This
product is not a toy.
Keep all components out of the reach of children when not in use.
ASSEMBLING INSTRUCTIONS
Fig. 4.1 Place silicone massaging cushion (fig. 1.A) in the funnel and
stretch the edges on the edges of the funnel (
fig.
1.B) in such a way
that they are tightly fitted.
Fig. 4.2
Place the membrane (fig 1.C) in the goblet at the top of the
body (fig. 1.B) so that it fits precisely and press the edges of the
membrane, then apply the membrane cap (1.D).
Fig. 4.3
Mount the valve (fig 1.E) in the hole underside of the breast
pump body (fig 1.B) by pushing it tightly to the end.
Fig. 4.4 Screw the adapter (fig. 1.O) onto the bottle (fig. 1.F). Tighten
the whole set to the underside of the body (fig 1.B) so that they
form a tight whole.
