CLEANING AND DISINFECTION INSTRUCTIONS
Before first and each subsequent use disassemble the breast pump. Wash all components of breast
pump and bottle in warm water with mild detergent, then rinse thoroughly and disinfect in accordance to
rules below.
Before first use,
disinfect all components which come in contact with mother's milk (membrane cap fig
1.d, membrane (fig. 1.C), breast pump body (fig. 1.B), silicone massaging cushion (fig. 1.A), dust cover
(fig. 1.G), silicone anti-return valve (fig. 1.E), bottle adaptor (fig. 1.O), bottle (fig. 1.F)) by placing them for
5 minutes in boiling water. This is to ensure hygiene.
NOTE!
Do not leave components on the bottom of
the pot. Stir the water during disinfecting to prevent damage to components.
Be sure that all components are completely submerged in boiling water during disinfection.
Do not boil
elements that don’t have direct contact with mothers’ milk and electric
elements (fig. 1: H, I, J, P).
Remove all components from water immediately after boiling.
Before subsequent use, disinfect all above mentioned elements of breast pump and bottle by pouring
with boiling water or placing in electric or microwave steam sterilizer, to ensure hygiene.
WARNING! Do not disinfect silicone tubing with connectors (fig. 1. H, I), and electric
elements Do not submerse these elements in water. Wipe with disinfectant.
After each disinfection completely, air- or towel-dry before reassembly and next use. Dried parts should
be stored in an airtight container or a plastic bag. You can also use a clean towel.
Warning!
Partially dry components may affect the operation of your Breast Pump. Make sure that all
parts are completely dry before use.
Washing instructions:
Always wash the product immediately after use to remove any residual milk.
Disconnect the tubing with connectors. These elements don’t need cleaning, because the
pumping membrane protects them from contact with feed.
Clean all components of the breast pump in accordance with the instructions mentioned above.
DO NOT use any solvents or chemicals to clean the product.
Rinse with clean, hot water.
If you use electric sterilizer for disinfecting elements please follow the instructions given by its
manufacturer.
Anti-return valve should be cleaned very carefully. Do not allow the food to dry out in the valve.
NOTE! Always disassemble the valve by carefully pushing its rim with your finger through the goblet of
the membrane at the top of breast pump body. Never grasp the end of the valve as it can get damaged
and weaken the strength of suction.
