Canon Saddle Finisher-T2, Руководство по обслуживанию

Страница: 166 / 262

Chapter 3
3-64
tray cable. To prevent the gear phase from shifting
due to the front and rear rails, the tray must be
attached horizontally. Lower the tray [1] to the
position shown in the figure and compare the
heights of the shutter guide top edges [2] with those
of the tray projections [3] at the front and rear to
check that the tray is attached horizontally. If their
heights are not the same, remove the tray and then
attach it again.
F-3-260
3.3.9.10 Removing the Grate-
shaped Lower Guide
0009-4108
1) Remove ten screws [1] and remove the grate-
shaped lower guide [2].
When replacing, be careful not to hook the grate-
shaped lower guide to the sensor flag arm on the
delivery side.
F-3-261
3.3.9.11 Removing the Upper
Delivery Guide
0009-4109
1) Remove two screws [1] and ground wire [2] and
remove the upper delivery guide [3].
F-3-262
3.3.9.12
Removing the PCB
Cover
0009-4110
1) Remove seven screws [1] and remove the PCB
cover [2].
[1]
[3]
[2]
[1]
[1]
[1]
[2]
[1]
[2]
[3]