Canon Saddle Finisher-T2, Руководство по обслуживанию

Страница: 152 / 262

Chapter 3
3-50
F-3-201
When installing the tray, be careful not to twist the
tray cable. To prevent the gear phase from shifting
due to the front and rear rails, the tray must be
attached horizontally. Lower the tray [1] to the
position shown in the figure and compare the
heights of the shutter guide top edges [2] with those
of the tray projections [3] at the front and rear to
check that the tray is attached horizontally. If their
heights are not the same, remove the tray and then
attach it again.
F-3-202
3.3.6.7 Removing the Tray 2
0009-3690
When moving the tray down to attach it, you need
to push the tray lift motor gear [1] to the front (using
a screwdriver or the like) to release the clutch.
However, when the clutch is released, the tray [2]
drops by its own weight. Be sure to hold the tray
with your hand when releasing the clutch.
F-3-203
1) Remove screw [1] and remove the stopper [2].
F-3-204
2) Remove the screw [1] and disconnect the connector
[2].
[1]
[1]
[3]
[2]
[2]
[1]
[1]
[2]