Canon Saddle Finisher-T2, Руководство по обслуживанию

Страница: 149 / 262

Chapter 3
3-47
F-3-189
7) Disconnect two connectors [1] and remove harness
from the clamp and edge saddle [2].
8) Remove two screws [3] and pull out the processing
tray [4] in the paper delivery direction.
When removing parts inside the processing tray,
be careful not to exert force on the aligning plate
(front/rear) or the rear end stopper plate.
F-3-190
3.3.5.10 Removing the Return
Roller
0009-3709
The return roller is subjected to special production
processing known as "aging" to prevent possible
increases in its feeding power. Do not clean the
return roller. Cleaning (with water, for example),
will increase its feed power, ultimately causing
feeding faults.
Moreover, be sure to avoid touching the surface of the
return roller when mounting it to the machine.
1) Remove two clips [1] of the return roller axis.
2) Pull out the return roller axis and remove two return
rollers [2] together with collar.
3) Separate the return roller and collar.
Note the direction when installing the return roller.
Front side : Black
Rear side : White
The paper will not stack properly if it is installed in the
wrong direction.
F-3-191
3.3.6
Return Roller Unit
3.3.6.1 Removing the Front
Door
0009-4462
1) Open the front door [1] and remove the clip [2].
2) Lift the front door [1] to remove.
[2]
[3] [4] [5] [1]
[4]
[3] [3]
[2]
[1]
[1]
[2]
[1]