Canon PIXMA MX7600, Руководство по обслуживанию

Страница: 10 / 67

2-2. Service Call Errors (by Cyclic Blinking of Alarm and Power LEDs)
Service call errors are indicated by the number of cycles the Alarm and Power LEDs blink, and the corresponding error code is
displayed on the LCD.
Cycles of
blinking of
Alarm and
Power LEDs
Error
Error
code
Conditions
Solution
(Replacement of listed parts,
which are likely to be faulty)
2 times Carriage error [5100] An error occurred in the carriage
encoder signal. - Carriage unit
- Timing slit film
- Logic board
- Carriage motor
3 times Line feed error [6000] An error occurred in the LF encoder
signal. - Timing sensor unit
- Timing slit disk film
- Feed roller
- Logic board
- Paper feed motor
4 times Purge cam sensor error [5C00] An error occurred in the purge unit. - Purge unit
- Logic board
5 times ASF (cam) sensor error [5700] This error takes place when paper feeds
from the rear tray after an error
occurred in the ASF cam sensor. - Sheet feed unit
- ASF_PE sensor board
- Logic board
6 times Internal temperature
error [5400] The internal temperature is not normal. - Logic board
7 times Ink absorber full [5B00,
5B01] The ink absorber is supposed to be full.
Message on the LCD:
Ink absorber full. Service required.
Error codes:
5B00: Main ink absorber is full
(overseas).
5B01: Main ink absorber is full
(Japan).
- Ink absorber kit
No wetting liquid [5250] The wetting liquid is used up. - Blade cleaner unit
8 times Print head temperature
rise error [5200] The print head temperature exceeded the
specified value. - Print head
- Logic board
Reactor error [B300] A hardware error in supply of the reactor
liquid.
- Valve unit
- Sheet feed unit
9 times EEPROM error [6800,
6801] A problem occurred in reading from or
writing to the EEPROM.
Error codes:
6800: Read error
6801: Write error - Logic board
10 times VH monitor error [B200] The VH output of the power supply to
drive the print head is abnormal.
- Print head
- Carriage unit
- Logic board
11 times Carriage lift mechanism
error [5110] The carriage did not move up or down
properly. - Sheet feed unit
- PR lift shaft ass'y
- Carriage lift sensor unit
- Logic board
12 times AP position error [6A00] An error occurred in the AP motor
during purging operation.
- Sheet feed unit
- Purge unit
- Logic board
13 times PF / RR position error [6B00,
B310] 6B00: An error occurred in the paper
feed motor during line feeding. - Sheet feed unit
- Logic board
8 / 65