Canon PIXMA MP640, Руководство по обслуживанию, Страница: 15 / 57

the service center for
replacement.
Error codes:
5B00: Main ink absorber
is full (overseas).
5B01: Main ink absorber
is full (Japan).
reset the ink absorber counter.
8 times Print head
temperature rise
error [5200] The print head temperature
exceeded the specified value. (1) Print head condition
(2) Head contact pin condition of the carriage unit
(3) Cable connection
(4) Part replacement:
- Print head
- Logic board
- Carriage unit
9 times EEPROM error [6800,
6801] A problem occurred in
reading from or writing to the
EEPROM. (1) Part replacement:
- Logic board
10 times VH monitor error [B200] The internal temperature
exceeded the specified value.
(1) Head contact pin condition of the carriage unit
(2) Cable connection (especially the carriage FFC)
(3) Part replacement:
- Print head and logic board (Replace them at the
same time.)
- Power supply unit
- Carriage unit
11 times Carriage lift
mechanism error [5110] The carriage did not move up
or down properly. (1) Foreign material or paper debris that obstructs the
carriage movement;
remove foreign material.
(2) Part replacement:
- Switch system unit
- Carriage unit
12 times APP position
error [6A80] An error occurred in the APP
motor.
(1) Foreign material or paper debris around the purge
drive system unit;
remove foreign material, and confirm that the
ink absorber right beneath the purge drive
system unit stays in place and does not contact
the unit.
(2) Foreign material or paper debris around the ASF unit;
remove foreign material.
(3) Cable connection
(4) Part replacement:
- Purge drive system unit
- Logic board
14 times APP sensor error [6A90] An error occurred during
paper feeding or purging.
Paper feed cam
sensor error [6B10] An error occurred in the paper
feed cam sensor during paper
feeding from the cassette, or
the paper absorbing a large
amount of ink jammed in the
PF rear guide.
(1) Jammed paper in the PF rear guide (when a large
amount of ink was absorbed in the paper);
remove the jammed paper and foreign material.
(2) Foreign material or paper debris in the cassette or in
the PF rear guide;
remove foreign material.
(3) Part replacement:
- PF pick-up unit
- Logic board
15 times USB host Vbus
overcurrent [9000] The USB host Vbus
overloaded. (1) Part replacement:
- Logic board
16 times Pump roller
sensor error [5C20] The pump roller position
cannot be detected.
(1) Cable connection
(2) Part replacement:
- Purge drive system unit
17 times Paper eject [6010] An error occurred in the paper (1) Smearing or scratches on the LF / EJ slit film;
12 / 54