Canon PIXMA MP640, Руководство по обслуживанию, Страница: 12 / 57

installed, or not
properly
installed. installed. Install the print
head. - Carriage unit
Faulty print head
ID. U052 The type of print head is
incorrect. Install the
correct print head.
Re-set the print head. If the error is
not cleared, the print head may be
defective. Replace the print head. - Print head
- Carriage unit
Print head
temperature
sensor error. [1403]
Faulty EEPROM
data of the print
head. [1405]
Inner cover error. [1841
*2
,
1846
*2
,
1851
*1
,
1856
*1
,]
--- Inner cover is open.
Close the inner cover and
press [OK]. Close the inner cover, and press the
OK button. - Spur unit
- Inner cover unit
[1850
*1
,
1855
*1
]
--- Open the inner cover,
place the CD-R tray and
press [OK]. Open the inner cover which functions
as the CD / DVD tray feeder, set the
CD / DVD tray in the feeder, and
press the OK button. - Spur unit
- Inner cover unit
Time-out in CD /
DVD print
operation.
[1830
*1
]
--- Timeout error has
occurred. Press [OK]. A prescribed period of time (12
minutes) has elapsed without any
printing since printing was attempted.
Press the Stop button to clear the
error.
Multiple ink tanks
of the same color
installed. [1487] U071 More than one ink tank
of the following color is
installed.
Replace the wrong ink tank(s) with
the correct one(s). - Ink tank
Ink tank in a
wrong position. [1680] U072 Some ink tanks are not
installed in place.
Install the ink tank(s) in the correct
position. - Ink tank
Warning: The ink
absorber becomes
almost full. [1700] --- The ink absorber is
almost full. Press [OK] to
continue printing.
Contact the service center
for replacement. Replace the ink absorber, and reset
its counter. [See
4-2. Service Mode. ]
Pressing the OK button will exit the
error, and enable printing without
replacing the ink absorber. However,
when the ink absorber becomes full,
no further printing can be performed
unless the applicable ink absorber is
replaced.
The ink absorber will
become full soon (service
call error).
The connected
digital camera or
digital video
camera does not
support Camera
Direct Printing. [2001] --- The device may be
incompatible. Remove
the device and check the
manual supplied with the
connected device. Remove the cable between the
camera and the machine.
Automatic duplex
printing cannot be
performed. [1310] --- This paper is not
compatible with duplex
printing. Remove the
paper and press [OK]. The paper length is not supported for
duplex printing.
Press the OK button to eject the
paper being used at error occurrence.
Data which was to be printed on the
back side of paper at error occurrence
is skipped (not printed). - Duplex printing feed
roller unit
- PE sensor board unit
Failed in
automatic print
head alignment. [2500] --- Auto head align has
failed. Press [OK] and
repeat operation. <See
manual> Press the OK button to clear the
error, then perform the automatic
print head alignment again.
(In the MP640 / MP648, use Matte
Photo Paper MP-101.) - Carriage unit
- Print head
- Purge drive system unit
9 / 54