Canon Paper Deck-V1, Руководство по обслуживанию

Страница: 77 / 90

Chapter 4
4-5
4.2.1.4 Swithcing the Paper
Size of the Deck
0009-4846
If the deck paper size configuration must be changed
to suit the needs of the user, perform the following:
1) Open the compartment [1] of the paper deck, and
remove all copy paper.
2) If the lifter of the paper deck in in up position, turn
on the host machine's power switch, and push the
lever of the paper supply level sensor [2] inside the
compartment so that the lifter will move down to its
lower limit.
F-4-6
3) Remove the screw [1], and move the paper trailing
edge guide plate [2] to suit the new paper size; then
secure it in place with a screw. (The rear end guide
plate will not be used for LTR size. The paper sizes
are marked on the bottom deck.)
4) Detach the front cover of the paper deck.
5) Remove the screws (one each) [3], and mount the
left right guide plates [4] to suit the new paper size.
6) Mount the front cover of the paper deck.
7) Set COPIER>OPTION>ACC>DK-P in the host
machine's service mode.(0:A4, 1:B5, 2:LTR)
F-4-7
4.2.2 Adjustment at Time of Parts
Replacement
4.2.2.1 Adjusting the Position
of the Deck Pickup Roller
Releasing Solenoid (SL101)
0009-2155
Take note of the positions of the two fixing screws [2]
of the solenoid with reference to the index on the
support plate before removing the deck pickup roller
releasing solenoid [1] from the support plate; or, mark
the position of the solenoid on the support plate with
a scriber.
If the solenoid is to be mounted on its own, be sure to
locate it in its initial position.
F-4-8
4.2.2.2 Stringing the Lifter
Cable
0009-4912
1) Check to make sure that the lifter drive shaft [1] and
the lifter [2] are fixed in place using a hex wrench
[2]
[1]
[2] [1] [3]
[4]
[1]
[2]