Canon Paper Deck-V1, Руководство по обслуживанию

Страница: 53 / 90

Chapter 3
3-11
F-3-40
6) Place the compartment [5] on the base you prepared
in step 1).
3.3.3.4
Removing the Deck
Lifter Motor (M102)
0009-2101
1) Disconnect the connector [1], and remove the 5
screws [2]; then, detach the deck lifter motor unit
[3].
F-3-41
3.3.4 Lifter Cable (Front)
3.3.4.1 Opening the
Compartment
0009-2102
1) Push the deck release grip to detach the deck from
its host machine. Then, push down the latch plate
[1] found at the rear left to open the compartment
[2].
F-3-42
3.3.4.2
Removing the Lifter
Cable (deck front)
0009-2104
1) If there is any paper, remove all.
2) Insert 2 long screwdrivers [1] to keep the lifter in
position.
3) So that the left and right holes of the compartment
side plate and the left and right holes of the lifter
will match, move down the lifter by pushing the
flag [2] of the paper supply position sensor.
- Connect the power plug, and turn on the host
machine's power switch.
- Push the flag [2] of the paper position sensor found
inside the compartment [3] until the deck lifter
comes into contact with the screwdrivers.
(The deck lifter will stop when you let go of the flag.)
F-3-43
4) Loosen the 4 screws [1], and detach the front cover
[2].
[1]
[4]
[3]
[4]
[2]
[5]
[1]
[2]
[2]
[3]
(rear)
[2]
[1]
[1]
[3]
[2]