16
16
Installation Procedure > Installing the Inner Finisher in the Host Machine
Installation Procedure > Installing the Inner Finisher in the Host Machine
14) Store the relay harness and switch harness of the host machine in the wire saddle of the
cover hinge mount included in the inner puncher carton. Then fix the cover hinge mount to
the host machine.
• 2 screws (RS Tightening; M3x8)
CAUTION:
Pay attention cable wires are not caught..
x2
15) With having the punch harness been free as shown in the figure, attach the finisher front
cover included in the inner puncher carton.
• 2 screws (RS Tightening; M3x8)
x2
F-1-37
F-1-38
16) Joint 2 connectors of the punch relay harness to the relay harness of the host machine
and lay the punch relay harness as shown in the fi gure.
NOTE:
1 junction connector (19 pins) on the host machine is not used.
x2
17) Install the staple in the stapler unit.
F-1-39
F-1-40