Canon IMAGERUNNER 7086, Руководство по обслуживанию

Страница: 78 / 615

Chapter 2
2-31
2.3 Checking the Connection to
the Network
2.3.1 Checking the Network Connections
0010-9001
Perform the following work only if the machine
is connected to a network.
1) Go through the shut-down sequence to turn off
the main power.
2) Connect the network cable to the machine, and
turn on the main power switch.
3) Tell the user's system administrator that the
machine has been installed, and ask him/her to
make the machine's network settings.
The following user mode items must be set to
'ON' when making network settings:
system administrator setup > network setup >
change network settings/check connection.
4) When the network settings have been made, go
through steps 1) thorough 3) to turn off and
then on the main power so that the settings will
become valid.
2.3.2 Using the PING Command
0010-9002
Perform the following work only if the machine
is connected to a network:
If the user environment is TCP/IP, use the PING
command to see if the main controller PCB has
been correctly mounted and the network settings
have been correctly made.
If the user environment is IPX/SPX or Apple-
Talk, on the other hand, these checks are not nec-
essary.
1) Make the following settings in service mode:
COPIER > TEXT > NETWORK > PING.
2) Type in the IP address using the control panel
keypad, and press the OK key.
3) Press the OK key.
- When the check with the PING command is
successful, 'OK' will be indicated; otherwise,
'NG' will be indicated.
F-2-123
2.3.3 Making a Check Using a Remote
Host Address
0010-9003
You can check to see if the connection to the net-
work is correct by executing the PING command
using a remote host address.
MEMO:
A remote host address refers to the IP address of
a PC connected to the TCP/IP network to which
the machine is also connected.
1) Tell the user's system administrator that you
are going to check the connection to the
network using the PING command.
2) Check with the system administrator to find
out the remote host address.
3) Type in the remote host address for 'PING'.
4) If 'OK' is indicated, the connection to the
network is correct.
5) If 'NG' is indicated, the connection to the
network is not correct; go though the following
steps:
0. 0. 0. 0
+/-
OK
<NETWORK> < 1/1 > <READY >
PING
[2]
[1]