17
Preparation Before Use
This chapter describes how to prepare the scanner to scan
documents.
Perform the following steps to set up the CR-135i II/CR-190i II. Refer to
the section for each step for details about that step.
A
Check your operating environment. (See “Checking Your
Operating Environment,” on p. 18.)
B
Install the software. (See “Installing the Software,” on
p. 19.)
Install the Scanning Utility provided with the CR-135i II/CR-190i II.
C
Connect the scanner to a computer. (See “Connecting
the Scanner to a Computer,” on p. 20.)
D
Turn ON the power. (See “Turning ON the Power,” on
p. 21.)
E
Automatically installing the device driver. (See p. 22.)
The device driver is installed automatically when Windows
recognizes the CR-135i II/CR-190i II.
IMPORTANT
•
To have the device drivers installed automatically when the computer
recognizes the CR-135i II/CR-190i II, the software needs to be installed
before the CR-135i II/CR-190i II is connected to the computer.
•
If you connect the computer and turn ON the CR-135i II/CR-190i II before
installing the software, the following wizard screen appears. If this
happens, click [Cancel], turn OFF the CR-135i II/CR-190i II, and then
install the software.
The following wizard screen is an example in Windows Vista. When a
similar wizard screen appears in Windows XP/7/8/8.1/10, click [Cancel].
Setting Up the Scanner
Wizard Screen (Windows Vista)