Canon HD XS HJ14ex4.3B, Руководство по эксплуатации

Страница: 36 / 110

E4
1
Select an object at an appropriate distance (HJ14ex: approx.
1 to 3m, HJ17ex/HJ18ex7.6B/HJ21ex/HJ24ex/KJ10ex/
KJ17ex/KJ22ex: approx. 2 to 5m, HJ18ex28B: approx. 5 to
7m recommended). Use any object with sharp contrast to fa-
cilitate the adjustment work.
2
Set the extender lever to 1x.
3
Set the iris fully open.
4
Set the lens to the telephoto angle by turning the z oom
ring.
5
Bring the object into focus by turning the focus ring.
6
Set the lens to the widest angle by turning the z oom ring.
7
Loosen the fl ange back lock screw, and turn the fl ange back
adjusting ring to bring the object into focus.
8
Repeat steps 4 to 7 a few times until the object is brought into
focus both at the widest end and the telephoto end.
9
Tighten the fl ange back lock screw.
1
Pull up the rubber cap on the iris gain adjusting trimmer.
2
Set the iris operation mode change-over switch to the “A”
(Auto) position.
3
Turn the iris gain adjusting trimmer, using a small
screwdriver. As you look at the lens iris ring, set it to the
position of maximum gain at which no iris hunting occurs.
4
Close the rubber cap after adjustment completes.
AM
RET
IRI
S
T
W
࢔࢖ࣜࢫືస࣮ࣔࢻ
HJ18ex7.6B IASE S
MEMO
AUX
18
㹶
Iris Operation Mode
Change-over Switch
Clockwise
(to increase gain)
Iris Gain Adjusting
Trimmer
Rubber Cap
3-2. IRIS GAIN ADJUSTMENT
An iris gain adjusting trimmer is located on the front of the lens drive unit. The iris gain is set at middle
of range at the factory. However, if you wish to change the iris gain, adjust the trimmer using a small
screwdriver.
This adjustment can be performed on the information display. Refer to the Information Display Manual.
3 ADJUSTMENT
3-1. BACK FOCUS ADJUSTMENT
If the relationship between the image plane of the lens and the image plane of the television camera is
incorrect, the object goes out of focus when the lens is
z oomed. Follow the procedure below to adjust
the back focus of the lens.
㻌
Flange Back
Adjusting Ring
Flange Back Lock Screw
Loosening
1x
2x
M
Extender Lever
3 ADJUSTMENT