Canon HD XS HJ14ex4.3B, Руководство по эксплуатации

Страница: 40 / 110

E8
1) If the z oom track position is to be set again, the z oom position cannot move beyond the end point setting
toward the mechanical end by performing servo z oom operations. To move the z oom, set the z oom track
function to OFF, then take one of the steps below.
・ Proceed with the z ooming operation at the setting established by operating the z oom rocker
seesaw.
・ Perform the z ooming operation manually.
2) Although up to two z oom track positions (the telephoto end and the widest angle end) can be set, two
positions cannot be set that are on the same side of the center position of the z oom range of this lens. (In
this case, the latest setting is stored as the z oom track position of this side.)
5-1-4. Zoom Track Function (only for servo zoom)
The z oom control range ( z oom track) position can be set as desired to set the virtual z oom limit in the telephoto
end and the widest angle end. To use the z oom track function, the function should be enabled in advance.
A ： Setting “ ON ” or “ OFF ” on the information display (In case of basic mode)
1
Press the DISPLAY switch to turn on the display.
2
Select [Trk] using the control key, and then press the Set key.
[Trk] and the previous setting now blink on the display.
3
Press the left or right key to select ON or OFF.
4
Press the Set key. This completes the setting.
For details, refer to the Information Display Operation Manual.
B: Setting “ON” or “OFF” by operating the switches
Shtl Fr1P
A 1 A2
MENU IG:50
Fr1P
A
[ I-Tq ] H
[ Z.M. ]
[Trk]OFF
AM
RE
T
IRIS
T
W
HJ18ex7.6B IASE S
MEMO
AUX
18
㹶
Instant Auto-Iris Switch
“MEMO” Switch
To set the
function to
"OFF"
To set the
function to
"ON"
Selection method Operation How to ascertain the selection
The zoom range is set to the
mechanical end.
Hold down MEMO
botton and Instant
auto-iris switch
simultaneously for
at least 3 seconds.
The zoom control range is fixed to the
zoom range set last.
(If there is no previous
setting, it is set to the mechanism end point.)
Automatic zooming from
current zoom position to the
closer of the two set positions.
Automatic zooming from current
zoom position to the closer of
the two mechanical ends.
Setting the Zoom Track Positions
Set the z oom track function to ON before setting the z oom track position.
1
Zoom to the z oom track position that you want to set.
2
Keeping this z oom position, press the Instant Auto-Iris switch while
holding down the MEMO switch. If the z oom position is at the tele-
photo end, the position is stored as the z oom track position for the
telephoto limit. If position is at the widest angle end, it is stored as
the widest limit.
3
Repeat step 1 and 2 to set both the telephoto and the widest limits.
It is possible to set only one end. To change the setting, perform
step 1 to 3. (The position set last overwrites the setting in the
memory.)
5 OPERATION